hua爱美食
(1)下列关于宽带城域网技术的描述中,错误的是 A)宽带城域网保证Qos的主要技术有RSVP、Diff-Serv和MPLS B)宽带城域网带内网络管理是指利用网络管理协议SNMP建立网络管理系统 C)宽带城域网能够为用户提供带宽保证,实现流量工程 D)宽带城域网可以利用NAT技术解决IP地址资源不足的问题 (2)下列关于接入技术特征的描述中,错误的是 A)远距离无线宽带接入网采用标准 B)Cable Modem利用频分利用的方法,将信道分为上行信道和下行信道 C)光纤传输系统的中继距离可达100km以上 D)ADSL技术具有非对称带宽特征,1,100分悬赏 DELL工程师考试题目 just replaced the system board on studio 1737 for a NO-power powering up the system,you notice that the system gives an ON-FLASHING-ON LED is the first step to be performed to resolve this issus? A: Reseat the keyboard cable B: Reseat the processor C: Reseat the momory modules D: Reseat the LCD cable results indicate a failure with the Dell edgetouch hardware in the latitude Z600. Which of the following ponents shoulc be replaced? A: LCD panel B: system board C: edgetouch control panel D: LCD BEZEL a Studio 1745/1747/1749 shipped with an internal TV Tyber card,what is the additional associated internal ponent? A: External TV Tuner antenna B: All the options are correct C: internal TV tuner cable assembly D: TV remote the replacement of a system board for the Vostro A860, system is still not able to post with the status lights shown as On/Flashing/On. Which status light is to be referred to and what does it mean? A: Refer to device status lights and it means faulty ram detected. B: Refer to keyboard status lights and it means faulty memory detected C: Refer to keyboard status lights and it means no ram detected. D: Refer to device status lights and it means no ram detected. part should be replaced next if the latitude E4200 system board has been replaced and the "flash-on-on" LED code is still displayed? A: RAM B: Solod state drive C: lcd D: processor items must be removed from the precision M6500 before the internal Memory can be removed from the system board? choose all that apply A: keyboard B: Hinge cover C: battery D: palm rest 最后一题多选
俺是陆军PLA
题库00914、如何按技术性质来判定水泥为合格品,不合格品和废品?(6分)答:1)当水泥中SO3含量, MgO含量, 初凝时间, 安定性这四项指标中有一项达不到要求,则此水泥为废品。2)当水泥中:细度,终凝时间,强度,不溶物,烧失量,混合料掺量等六项指标中,有一项不满足要求,此水泥判定为不合格。3)所有上述指标全部达到规范要求者,可判定为合格水泥..题库00913、水泥砼配合比设计中的主要参数有哪些?各反映了什么关系?(6分)答:三个主要参数为w/c, SP, W.其中w/c反映了水与水泥之间的比例关系。SP反映了集料之间的比例关系.W反映了水泥浆与集料之间的比例关系题库00912水泥砼的配合比设计由哪几部分构成?各部分的主要任务是什么?答:1)计算“初步配合比”:根据原材料资料,按我国现行的配合比设计方法,计算初步配合比.2)提出“基准配合比”:根据初步配合比,采用实际施工材料进行试拌,测定拌和物的工作性,调整材料用量提出满足工作性要求的基准配比.3)确定“试验室配比”,确定既符合强度和工作性要求,又较经济的试验室配比.4)提出“施工配比”:根据工地现场材料实际含水率,换算为工地配比.题库00912、简述重交通与中、轻交通量道路石油沥青技术要求的区别与联系。答:区别:在技术指标中,除路用石油沥青规定的有关指标外,其中重交通道路石油沥青延度的温度为15℃,蒸发损失试验改为薄膜烘箱试验.并引入含蜡量和密度两项指标.联系:都以针入度划分标号:并对软化点,溶解度及闪点等作了相应要求.题库00911、水泥砼的试配强度fcu , o与什么因素有关?如何确定它?答:○1.水泥砼设计要求的砼强度等级fcu,k;○2.施工单位质量管理水平;③强度保证率。题库00910、热拌热铺沥青混合料的拌和时间是如何确定? 答:当每一锅出料后,目测认为不合适,则需重新进料,适当延长拌和时间。反复几次,直至合格为止,此时的拌和时间再加上3-5s即为正式生产时的拌和时间,当第一锅出料后,虽目测合格,须适当缩短时间重新试拌,反复几次,直至不合格料出现为止。取不合格料出现前一次合格料的拌和时间再加3-5s即为正式生产时的拌和时间。
优质工程师考试问答知识库