小音箱说明书英文

Thank you for choosing MICROSTAR Bluetooth Speaker, in order for you to play all the performance of this product, please read this manual before use. ■ Description Bluetooth module is the audio encoding for the current market demand and development of audio development platform, multi-media products to increase the U disk and SD card playback easier and more convenient with a 2.0 amp output, with good sound quality, low distortion characteristics. ◆ Support MP3 audio format player ◆ with FM (87.5-108MHZ) ◆ 2.0 amp output ◆ support song memory ◆ Integrated USB2.0 full-speed host controller ◆ SD / MMC CARD Controller ◆ Provide all the way Line IN input control ◆ U disk, SD card inserted after automatically converting to a person, ◆ with three buttons: PREV / VOL-, PLAY / PAUSE, NEXT / VOL + ◆ Power Supply: built-in battery 3.7V ◆ Mini USB-powered, rechargeable. ◆ Output power: 2 X 2W ■ Keys Description 1. VOL-: on the one, long press the volume reduction 2.: Play / Pause, press once to FM mode, press and once again to LINE mode, then press and later to MP3 mode 3. VOL +: Under one, long press the volume increase Press and once for 3 seconds Remote control function 1, MODE: mode button, MP3, FM, Line input 2, PREV: on the one, the FM, in order to listen to radio on a radio, press and semi-automatic search for the upward 3, NEXT: the next one, in the FM, in order to listen to the next station, press and hold down semi-automatic search for the 4, PLAY / PAUSE: Play / Pause 5, VOL-: volume reduction 6, VOL +: Volume increase 7, EQ: standard, classic, bass, jazz, rock, pop 8, 0,1,2,3,4,5,6,7,8,9,100 + (when in the FM frequency reduction), 200 + (in the FM frequency when added): the number keys, portfolio selections : To select 13, press the number key 1 and then in three seconds 3 To select 103, press the number keys 100 + in three seconds and then 3 To select 133, press the number keys 1 three seconds and then in three seconds and then 3 3 ■ Note: A player input voltage is too high will damage the player, the voltage is too low, the player will not work, be careful not to take the wrong "+""-" pole. 2 player supports most USB flash drive (flash drive), SD card. Very small USB flash drive (flash drive), SD card itself is not unstable or too slow to support. 3 This player can not switch the USB and health by MODE SD, only inserted after the first. 4 player is an external 2.5 audio cable (about 50cm) Insert Line IN input as the FM antenna, such as the radio antenna is not inserted less effective. Thank you for purchasing MICROSTAR products

MICROSTAR

1. Connect speakers around Brought卫星箱put on a black 3.5 stereo plug to connect from behind a low speaker Machine "OUTPUT" terminals on headphones and pay attention to host 3.5 Do not plug stereo plug green signal line insert "OUTPUT" terminals on. 2. Connect Sound The use of host "3.5 stereo plug line" to connect to sources such as PC/MP3 (note the plug must be inserted in place) 3. Connect audio adapter AC plug adapter to access sources of AC power (100-240V/50/60HZ) the other side of the main access to the DC plug on the chassis backplane "DC10V1.3A" port 4. Playback Put the main knob to adjust the volume to a suitable position, open the power switch "ON" position, according to your likes to adjust the bass volume knob, E202 was intoxicated by the magic charm

1.连接左右音箱 把卫星箱上所带的连线黑色3.5立体声插头接到低音箱后面机的“OUTPUT”耳机端子上，注意别把主机3.5立体声插头绿色插头信号线插入“OUTPUT”端子上。 2.连接音源 使用主机“3.5立体声插头线”连接到PC/MP3等音源（注意插头一定要插到位） 3.连接音源适配器 将音源适配器AC插头接入交流电源（100-240V/50/60HZ）另一端的DC插头接入主机箱背板上的“DC10V1.3A”端口 4.放音 把主音量调节旋钮调至适当位置，打开电源开关“ON”位置，根据你的喜欢来调节低音音量旋钮，即被E202的神奇魅力所陶醉1 links the speaker The satellite box on the black belt attachment plug got 3.5 stereo speakers of low OUTPUT "behind the headset terminals, attention," don't host 3.5 stereo plug signal OUTPUT "green plug insertion" terminal. 2 connect the source USES a host "3.5 stereo plugs line" connected to the PC/MP3 audio etc. (note plug must be plugged in place), 3 connection audio adapter Will the source of AC adapter plugs into the AC power source (100-240V / 50/60HZ) at the other end of the DC plugs into the back of the mainframe box DC10V1. "aaa" port 4 playback The main volume adjustment knob to proper position, turn ON the power switch according to "ON" position, you like to adjust volume knob, which was bass E202 mesmerised ling-lasting charms